SELLEYS Knead It Steel 50g
A versatile hand kneadable, fast setting, non-rusting co-extruded epoxy repair system that can be used for repairing ferrous and aluminum metal items. It comes in a handy roll form, with the black hardener encapsulated in the grey resin part. The product hardens in 5-10 minutes, after mixing, to a black metal-like material.
Features
Features
- Will not sag, run or drip
- Easy to use - no mess
- Can be drilled, sawed, sanded, filed, tapped, machined or painted one hour after mixing
- Good adhesive strength
- Can be used to reshape, rebuild and repair a multitude of surfaces and applications
- Good gap filling properties
- Long-lasting, durable solution
- Heat resistant to 120°C continuously or 140°C intermittently
- Can be used under water. (but dry surfaces for application are best and recommended)
- Rapid set time (<10 minutes)
- Can be used for fuel resistant repairs.
Ideal for
- Steel
- Wide range of terrous metal and aluminum items
- Most plastics (pre-test required)
- Glass
Direction
- Clean surface free of grease, dirt and dust. For best results roughen bond area prior to cleaning.
- Cut off required amount. Replace disc on remaining portion. Use gloves to avoid messing hands. To mix, knead with fingers to a uniform colour. If mixing is difficult, warm to room temperature.
- Apply to surface to be repaired (within 2 minutes of mixing) and mould to shape if required.
- For a smooth appearance, remove excess and hand rub with water or a damp cloth before hardening begins.
- Trim away any excess before initial hardening. Remove any residues with acetone prior to initial hardening. Hardened excess may be sanded or trimmed away once fully cured.
- After 5-10 minutes Knead-It Multi Purpose will harden and begin to form a strong bond.
- After 60 minutes Knead-It Multi Purpose may be drilled, sanded, machined, filed, sawed or painted.
- Wash hands thoroughly with soap and water before product hardens.
Safety tips
- Where possible wear protective gloves when using Knead-It Multi Purpose. Contact with skin may result in irritation. Epoxy resin is a known skin sensitiser. Repeated or prolonged skin contact may lead to allergic contact dermatitis.
- If redness or swelling of skin occurs, wash thoroughly with soap and water. Seek medical attention if in any doubt.
- Mixed and cured material is not hazardous. Cured material can only be removed by cutting and abrasion. If cured on skin, it will peel off in a few days without assistance. Soaking in warm water will assist removal.